Vox Tonelab EX Manuel du propriétaire télécharger pdf (Page 12)

A Guitarist’s Guided Panel Tour

Here we’re going to learn about the buttons and other controls on ToneLab LE’s top and rear

panel.

THE TOP PANEL

MODEL SELECT SECTION

Here you can select the model of amp, cabinet and effect models.

1.1 MODEL select buttons

Use these when selecting the effect category you want to edit with value knobs 1–6, and

when switching effects on/off. If an effect you’re using is ON it will be lit (or blinking during

editing), and if OFF it will be dark.

Press a button once and its LED will blink; now you can use value knobs 1–6 to edit the

parameters of that effect.

If you want to turn off an effect that is currently on, press the model select button for the

appropriate effect once (it blinks), and then press that model select button once again to

turn it off (dark); the name display will indicate [--OFF--].

The pedal effect is placed in front of the amp model and the modulation, delay, and reverb

are placed after the cabinet model.

NOTE: The reason that modulation, delay, and reverb effects are placed after the amp — rather than

before it as a “stompbox” — is that they sound better and more realistic. For example, REVERB

emulates the sound created by a room or hall. So, logic dictates that if we’re going to add it to

our sound, the closer to the end of the signal chain we put it, the more “real” and natural it’s

going to sound. The same is true for DELAY and MODULATION effects — they’re going to

sound more natural if added near the end of your signal path, not at its beginning. Also, if you’re

1.2

1.4

1.3

1.5 1.6 1.7 1.8

1.1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 58 59

Pas de commentaire

Vox Tonelab EX Manuel du propriétaire Page 12