Vox Tonelab EX Manuel du propriétaire télécharger pdf (Page 8)

HINT:

If you want to replicate the sound of the original amp, set [VR GAIN] to the maximum setting on

vintage-type models that do not have a master volume control (i.e., AC15, AC15TB, AC30,

AC30TB, UK BLUES, UK 68P, BLACK 2x12, TWEED 1x12, and TWEED 4x10). For modern-

type amps that have a master volume control, adjust [VR GAIN] in the same way that you would

on the original amp. When the [VR GAIN] setting is low, preamp-type distortion will occur. As

you raise the [VR GAIN] setting, the pre-amp will begin loading the Valve Reactor to cause clip-

ping, and the warmth and distortion of the Valve Reactor will be added.

14.

ToneLab LE provides a PEDAL effect that is placed before the amp, and MODULATION,

DELAY, and REVERB effects that are placed after the cabinet.

For example if you want to use the PEDAL effect TREBLE BOOST, turn the PEDAL selector

to select TREBLE BOOST. The PEDAL parameter LED of the edit section will blink, indicat-

ing the parameter line (the region listing the parameter names). Also, the LEDs below the

value knobs will light, indicating the location of the knobs that you can use to control TRE-

BLE BOOST. Now turn value knobs 1, 2, and 3 to adjust DRIVE, LEVEL, and TONE respec-

tively. You can edit other effects using the same procedure.

HINT:

Some effect settings may cause unwanted distortion (if there is such a thing!!). If this happens,

lower the PROG LVL.

(p.25)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 58 59

Pas de commentaire

Vox Tonelab EX Manuel du propriétaire Page 8